Manual Call Point

Product Details:

• For manually activating the alarm in zones 1 and 2 at risk of explosion
• Suitable for applications with Ex detectors
• Especially robust, weatherproof housing
• Adjustment of the manual call point after alarm triggering
• Robust plastic casing of impact-resistant polycarbonate
• Indicator LED for alarm or for inspection evaluation
• Individual labeling: fire department or fire detector
• Adjustment of the manual call point after alarm triggering
• Surface-mounted and flush-mounted cable feed possible

Product Details:

Other Detail:

• Manual call points for addressed Sinteso FS20 and Cerberus PRO FS720 fire detection systems
• Very robust housing design made from fiberglass-reinforced thermoplast 
• For surface mounting in humid, wet and dusty environments
• Manual call point FDM223H with indirect activation: type 'B' according to EN 54-11 
• Manual call point FDM224H with direct activation: type 'A' according to EN 54-11 
• Two-wire installation for all cable types 
• Communication via FDnet/C-NET (addressed individually)

Product Details:

Other Detail:

• Slimline design
• Low power consumption
• Plug-in connection clamps
• Optional terminal clamps
• 2 x cable entries on top, at the bottom and on the rear panel
• Fixing on standard flush mounted installation box
• Test function via manual call point service key
• Detectors that are not ready for operation can be marked with the "Out of order" label by reversing the enclosed operating front foil

Product Details:

The HM-MCP-GLASS Call Point is designed to provide a manualalarm interface to Morley IAS’s fire alarm control panel.

Product Details:

The 2099 series addressable pull station employs an individually addressable module (IAM) to provide constant monitoring of the station’s status. Changes in status are communicated to the control panel across the MAPNET® communication lines.

Product Details:

• Other Detail:
  
  • Slimline design
  • Low power consumption
  • Plug-in connection clamps
  • Optional terminal clamps
  • 2 x cable entries on top, at the bottom and on the rear panel
  • Fixing on standard flush mounted installation box
  • Test function via manual call point service key
  • Detectors that are not ready for operation can be marked with the "Out of order" label by reversing the enclosed operating front foil