Detector Base

Product Details:

Detector base with relay contact output, for ES Detect detector family. Suitable for 48 V DC operation.

Contact: floating normally open or normally closed, selectable via coding strap, factory setting: normally closed (NC).

The smoke detector of Series ES Detect used in the detector base can be reset manually or automatically by a short interruption (4 seconds) of the detector voltage.

A typical use for this base with ES Detect detector is to monitor mobile communication stations.

• Part-No.: 805592

System benefits:

• Optimally matched to the ES Line system
• With multisensor detectors for the detection of all fires, even under the most difficult operating conditions
• Up to 30 detectors per detection group

Reliable detection:

• Uniform response sensitivity of the detector for all different types of fire for the multisensor detectors
• Large distance between signal and interference magnitudes due to special sensor and electronics design for suppressing electromagnetic influences
• Automatic adaptation to varying environmental influences
• Electronic compensation also called drift-compensation of long-term influences of contamination or aging

Reliable false alarm suppression:

• High reliability against false alarms by temporal evaluation of different sensor criteria, with built-in insect screen and sealed against rear air flow entry
• Exclusion of signal forms not typical of fires through special filter algorithms
• Automatic self-monitoring of the detector electronics
• Automatic self-monitoring of sensors for function and condition

Maintenance:

• Designation of the heat detector by a black ring on the light pipe
• Hours of operation, alarm and fault counter in each detector
• Operation data retrieval of all detectors of a group with standard service PC and field bus interface
• Detector LED for alarm display and as an identification display in the service (for maintenance with 8000 tools)

Wide range of accessories:

• Standard socket and relay base
• Socket adapter for ceiling installation
• Dust caps optional for fire detectors and detector base
• Kit for suspended mounting

• Quiescent current  approx. 0,051 mA 
• Current consumption  max. 9 mA Alarm current @ 9 V DC  9 mA 
• Contact load relay  30 V DC / 1A, 60 V DC / 0,45 A 
• Area to be monitored  110 m² 
• Height to be monitored  12 m Air velocity  0 m/s ... 25,4 m/s 
• Application temperature  -20 to 72 Degree Celsuis
• Storage temperature  -25 to 75 Degree Celsuis 
• Air humidity  < 95 % (non-condensing) 
• Type of protection  IP 40 with base, up to IP 43 with base and option  base) 
• Detector specification  EN 54-7 

Product Details:

• Ease of installation and a lot of space for wire connection
• Slide-easy base and elegant design with automatic closing of the loop bus wiring system for detector extraction
• Detector extraction locking is enclosed in the base
• One-way only fit

Product Details:

IQ8Quad detector base with relay contact output. Contact: floating NO or NC contact selectable via jumper. Settings on site: NO contact.

• Provides a voltage-free contact controlled by the remote output of a detector
• Draws negligible current
• A lot of space for wire connection
• Automatic closing of the loop bus wiring system for detector extraction
• Detector extraction locking is enclosed in the base

Product Details:

The IQ8 detector base is painted and delivered according to the required RAL color. For identical colors, it is suggested to order a suitable number of additional pieces.

Recommendation: Please calculate a 10% spare quantity of the volume needed, as the devices can be

- damaged by transportation,

- damaged during installation or

- the end customer may need further quantities later (e.g. extension) and the lacquer producer cannot guarantee to match the same color nuance again!

Product Details: